How To Repair 98 Beetle Dash Vents

How to Remove a Mouse Nest From a Car'due south Ventilation System

Are yous tired of stinking mice in your car ventilation organization? Endeavor these steps.

During the winter, mice love to become into cars and build nests in the ventilation organisation, usually in the blower fan. To set up this, you can either take the auto to the shop and pay them a couple hundred dollars to have them remove it, and then pay this over again when the mice come back, or you lot can practice it yourself at dwelling, and while you are at it, make sure the mice never come back.

Here is a guide for the second option. I did this on a 2002 Toyota Sienna and a 2004 Toyota Camry. The pictures below are from the Camry, but whatsoever your make or model, the steps will be like.

Step 1: Remove the Air Intake Cover

Open the hood to your motorcar, and carefully remove the plastic air intake encompass. Information technology is below the windshield and is unremarkably attached with some plastic clips or screws. I used the screwdriver and needle nosed pliers at this stage. On the Camry, I had to remove the windshield wipers, merely this was not necessary on the Sienna.

Coil to Continue

Stride 2: Clean Out Blower Fan Housing

In one case the plastic cover is removed, y'all can see how the mice are getting into the blower fan. There is a water drain hose that goes down the side of your vehicle. They climb up that, and then down into the ventilation system through the air intake opening. If there is a nest inside, clean it out with your mitt or with a vacuum if you have 1 available.

NOTE: Make sure you lot wear gloves and a confront mask, as there may be mouse debris inside, which can bear various diseases and viruses.

Here's another picture for Stride two. This one is more than of a shut-upwardly of the opening where the mice get down into the ventilation organisation. I've already cleared out the nest that was in there, so y'all tin can see the blower fan.

To go along the mice from returning, put some wire mesh over the hole. The hardest role is attaching the mesh permanently. The Sienna had some screws I took out, then put back in afterwards laying the mesh downwardly. On the Camry, I had to drill some holes and put in some screws on the intake shaft to fasten the mesh.

Step 4: Put the Plastic Air Intake Cover Dorsum on

Put it all back together, and yous're washed! Y'all just saved yourself nigh $200, plus any other impairment the mice might have done to your blower fan and ventilation system.

This article is authentic and true to the all-time of the author's knowledge. Content is for advisory or entertainment purposes just and does not substitute for personal counsel or professional communication in business organisation, fiscal, legal, or technical matters.

If you lot're thinking virtually trying to come up up with some cool car name ideas for your vehicle, then this is the article to give you a jump start on the process.

Do you know what to do in the event that you arrive and turn your car on but it doesn't commencement? Check out this article for some helpful tips on what to do.